東莞賽森特空氣增壓機利用大面積活塞端的低壓氣體驅動而產生小面積活塞端的高壓流體.可用于壓縮空氣及其它氣體,輸出氣壓可通過驅動氣壓無級調節.下面我們看一下氣體增壓泵的增壓比:

     Gas booster pump using low-pressure gas a large area of the piston end driven and produce the high pressure fluid of small area of the piston end. Can be used for compressed air and other gases, the output pressure can be adjusted by a pressure driven stepless. Here we see the gas booster pump pressure ratio:

     空氣增壓機的增壓比實際為驅動活塞與高壓活塞(或柱塞)的面積比.氣體增壓泵的驅動氣壓要求為0.3-0.8MPa,對于一款增壓泵來講,增壓比是固定的,驅動氣壓0.3-0.8MPa,并不是講0.3MPa與0.8MPa,增壓泵的輸出壓力是一樣的,輸出壓力是根據驅動氣壓的變化而變化的,所以在選型時不能只看氣體增壓泵的da輸出壓力,也要看一下工廠的壓縮空氣的供氣狀況.

     Pressurized gas booster pump than the actual driven piston and the high pressure piston (or plunger) area ratio. The gas booster pump driven pressure requirements for 0.3-0.8MPa, for a booster pump, pressure ratio is fixed, the driving pressure of 0.3-0.8MPa, is not about 0.3MPa and 0.8MPa, increase the output pressure of the pressure pump is the same the output pressure is, change according to the change of the driving pressure, so not only the maximum output pressure gas booster pump in the selection, also want to see the factory compressed air supply conditions.